Re: Airport don't work only with me... WHY?? am I ill-fated ?

I dont know if you resolved this & I am speaking up late (just looked at
your mail) but from your dmesg, it looks to me like your wireless is fine &
the problem is on the WAP side.  Is there a mac filter on the WAP?  It looks
like you are sending or attempting to send an auth request & are getting no
response.  The first thing that comes to my mind is that there is a mac
filter on the WAP & it is ignoring your request.  second thought is that
your wireless encryption is sending a malformed request.

given the dmesg log, it looks like your chip is recognized & you are
scanning.  You even found a WAP to communicate with.

regards

On 7/21/06, peppeska <[email protected]> wrote:
>
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
>
> Well i've do what says Javier:
> (The first step is bringing up the interface "ifconfig eth0 up" before
> doing any wireless-related step. After the wireless-related steps you
> have to  configure your ip address (statically or by dhcp). )
>
> But nothing.. look my dmesg:
>
>
> bcm43xx: Core 4: ID 0x804, rev 0x9, vendor 0x4243, enabled
> bcm43xx: PHY connected
> bcm43xx: Detected PHY: Version: 2, Type 2, Revision 2
> bcm43xx: Detected Radio: ID: 2205017f (Manuf: 17f Ver: 2050 Rev: 2)
> bcm43xx: Radio turned off
> bcm43xx: Radio turned off
> ieee1394: Host added: ID:BUS[0-00:1023]  GUID[000d93fffe5fdf0c]
> eth0: Link is up at 100 Mbps, full-duplex.
> eth0: Pause is disabled
> eth0: Link is up at 100 Mbps, full-duplex.
> eth0: Pause is disabled
> bcm43xx: PHY connected
> bcm43xx: Radio turned on
> bcm43xx: Chip initialized
> bcm43xx: DMA initialized
> bcm43xx: 80211 cores initialized
> bcm43xx: Keys cleared
> SoftMAC: Start scanning with channel: 1
> SoftMAC: Scanning 14 channels
> SoftMAC: Scanning finished
> SoftMAC: Associate: Scanning for networks first.
> SoftMAC: Start scanning with channel: 1
> SoftMAC: Scanning 14 channels
> ieee80211_crypt: registered algorithm 'WEP'
> bcm43xx: set security called
> bcm43xx:    .active_key = 0
> bcm43xx:    .level = 1
> bcm43xx:    .enabled = 1
> bcm43xx:    .encrypt = 1
> SoftMAC: Scanning finished
> SoftMAC: Queueing Authentication Request to 36:33:95:bb:38:66
> SoftMAC: cannot associate without being authenticated, requested
> authentication
> SoftMAC: Sent Authentication Request to 36:33:95:bb:38:66.
> SoftMAC: Sent Authentication Request to 36:33:95:bb:38:66.
> SoftMAC: Sent Authentication Request to 36:33:95:bb:38:66.
> SoftMAC: Sent Authentication Request to 36:33:95:bb:38:66.
> SoftMAC: Sent Authentication Request to 36:33:95:bb:38:66.
> SoftMAC: Authentication timed out with 36:33:95:bb:38:66
> SoftMAC: cannot associate without being authenticated, requested
> authentication
>
>
> what's wrong?? Have I to buy a usb-wifi dongle for my ibook?
> - --
>   <<<<---------------------------------------------------------->>>>
>   |Giuseppe Moscato aka peppeska - Linux User - no html messages---|
>
>   |[email protected] - http://peppeska.altervista.org------|
>
>   |Fingerprint = 6C12 8341 9F08 1783 454A  A6D9 67AB 0695 EAC1 F02F|
>   <<<<---------------------------------------------------------->>>>
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v1.4.2.2 (GNU/Linux)
> Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org
>
> iD8DBQFEwJ6RZ6sGlerB8C8RAmDjAJ0QO4vszXBvFyzQtnxNRfdoEwIwOgCguDuf
> o3g6FufB1v1QmCMFnQOy9nE=
> =zJ/C
> -----END PGP SIGNATURE-----
> --
> [email protected] mailing list
>
>