rc-problem
Björn Schöpe <[email protected]>
| Newsgroups | gmane.linux.gentoo.ppc |
|---|---|
| Message-ID | <[email protected]> |
Hi everyone! Finally I got Gentoo installed on my PowerMac G4. The genkernel compiled fine, with the normal one I had some problems, so I chose genkernel. The system boots with error messages all about rc-problems. I have no network working and cannot connect with internet, so I cannot install any other tool, net-setup don't work. Always after doing a rc-update, env-update and as I said above, while booting it seems to work but I get a lot of errors, always the same, just repeated: Quote: /var/lib/init.d/depcache: line 1: q#: command not found While booting it is: Quote: /sbin/rc: line 1: q#: command not found This problem is posted also here: http://forums.gentoo.org/viewtopic-p-2265341-highlight-.html#2265341 with my configs if you need them. For further details ask me. Thanks for all comments! -Bjoern. -- Composed and send with Thunderbird on Debian "Sarge" (PPC) -- [email protected] mailing list