RE: initializing gentoo on ibook 12"
Dræven <[email protected]>
| Newsgroups | gmane.linux.gentoo.ppc |
|---|---|
| Message-ID | <[email protected]> |
Flavio, I believe in the kernel sources, if you go under the drivers section, de-select the driver for the i8042 Serial Controller. This used to cause me to have all sorts of problems like you described on my 800mhz TiBook. I can't recall where exactly in menuconfig it is, as I'm rebuilding right now and don't have the kernel sources installed yet :( If someone else could help out! --- Dræven -----Original Message----- From: Flavio Leonardo Cavalcanti de Moura [mailto:[email protected]] Sent: Tuesday, July 05, 2005 10:15 PM To: [email protected] Cc: Flavio Leonardo Cavalcanti de Moura (MAT-GRAD) Subject: [gentoo-ppc-user] initializing gentoo on ibook 12" Hi! I have just installed gentoo on my ibook 12". It has dual boot with yaboot. Sometimes it works fine but sometimes, without any reason it starts as follows and stop: NET: Registered protocol family 16 PCI: Probing PCI hardware PCI: Cannot allocate resource region 0 of device 0001:10:18.0 PCI: Cannot allocate resource region 0 of device 0001:10:19.0 SCSI subsystem initialized usbcore: registered new driver usbfs usbcore: registered new driver hub Thermal assist unit not available Registering PowerMac CPU frequency driver Low: 599 Mhz, High: 1199 Mhz, Boot: 599 Mhz Installing knfsd (copyright (C) 1996 [email protected]). NTFS driver 2.1.22 [Flags: R/W]. inotify device minor=63 Generic RTC Driver v1.07 Macintosh non-volatile memory driver v1.1 PCI: Enabling device 0000:00:10.0 (0006 -> 0007) radeonfb: Invalid ROM signature 0 should be 0xaa55 radeonfb: Retrieved PLL infos from Open Firmware radeonfb: Reference=27.00 Mhz (RefDiv=12) Memory=190.00 Mhz, System=183.00 Mhz radeonfb: PLL min 12000 max 35000 radeonfb: Monitor 1 type LCD found radeonfb: EDID probed radeonfb: Monitor 2 type no found radeonfb: Power Management enabled for Mobility chipsets Console: switching to colour frame buffer device 128x48 Registered "mnca" backlight controller, level: 15/15 radeonfb: ATI Radeon \c DDR SGRAM 32 MB i8042.c: i8042 controller self test timeout. Serial: 8250/16550 driver $Revision: 1.90 $ 8 ports, IRQ sharing disabled At this point it stops and nothing happens.... if I try to restart the machine it usually works, but ssometimes I need to restart it more than once. Does anyone know what is the problem? Best regards, Flavio Leonardo Cavalcanti de Moura email: [email protected] homepage: flavio.mat.unb.br -- [email protected] mailing list -- [email protected] mailing list