Re: [gentoo-user-hu] Re: CD eject probléma

A config magától generálódik, minden induláskor.

$ sudo grep 0000:03:00.0 /var/log/dmesg
pci 0000:03:00.0: reg 24 32bit mmio: [0xf8000000-0xf8001fff]
pci 0000:03:00.0: PME# supported from D3hot
pci 0000:03:00.0: PME# disabled
ahci 0000:03:00.0: version 3.0
ahci 0000:03:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
ahci 0000:03:00.0: AHCI 0001.0000 32 slots 2 ports 3 Gbps 0x3 impl SATA mode
ahci 0000:03:00.0: flags: 64bit ncq pm led clo pmp pio slum part
ahci 0000:03:00.0: setting latency timer to 64


$ sudo grep 0000:03:00.1 /var/log/dmesg
pci 0000:03:00.1: reg 10 io port: [0xc000-0xc007]
pci 0000:03:00.1: reg 14 io port: [0xc100-0xc103]
pci 0000:03:00.1: reg 18 io port: [0xc200-0xc207]
pci 0000:03:00.1: reg 1c io port: [0xc300-0xc303]
pci 0000:03:00.1: reg 20 io port: [0xc400-0xc40f]
jmicron 0000:03:00.1: IDE controller (0x197b:0x2363 rev 0x02)
pci 0000:03:00.1: enabling device (0000 -> 0001)
pci 0000:03:00.1: PCI INT B -> GSI 17 (level, low) -> IRQ 17
jmicron 0000:03:00.1: 100% native mode on irq 17
pci 0000:03:00.1: setting latency timer to 64

Sajnos nem vagyok tisztában vele, hogy a PCI buszon milyen szabályok
szerint történik az eszközök számozása, de ha a .1 végűt összevetem a
korábban írtakkal, akkor lehet némi tartománybeli egyezést
megfigyelni:

ide0 at 0xc000-0xc007,0xc102 on irq 17
pci 0000:03:00.1: reg 10 io port: [0xc000-0xc007]

ill.:

ide1 at 0xc200-0xc207,0xc302 on irq 17
pci 0000:03:00.1: reg 18 io port: [0xc200-0xc207]


Persze lehet, hogy ez két teljesen külön álló buszon szereplő
címtartomány és csak véletlen egybeesésről van szó.

2010/6/23 cjvt <[email protected]>:
> Nem biztos de ez alapjan a NEC-nek a rule-ban nem a
> pci-0000:03:00.0 -on kene lennie?
>
>
> 2010. június 23. 22:44:52 dátummal Bukuli Norbert az alábbiakat írta:
>> Úgy értettem, hogy egy eject folyamán nem keletkezik semmilyen
>> bejegyzés a dmesgben.
>>
>> A vonatkozó sorok:
>> Probing IDE interface ide0...
>> hda: _NEC DVD_RW ND-3500AG, ATAPI CD/DVD-ROM drive
>> hdb: PIONEER DVD-RW DVR-111D, ATAPI CD/DVD-ROM drive
>> hda: host max PIO5 wanted PIO255(auto-tune) selected PIO4
>> hda: UDMA/33 mode selected
>> hdb: host max PIO5 wanted PIO255(auto-tune) selected PIO4
>> hdb: UDMA/66 mode selected
>> Probing IDE interface ide1...
>> ide0 at 0xc000-0xc007,0xc102 on irq 17
>> ide1 at 0xc200-0xc207,0xc302 on irq 17
>> ide_generic: please use "probe_mask=0x3f" module parameter for probing
>> all legacy ISA IDE ports
>> ide-gd driver 1.18
>> ide-cd driver 5.00
>> ide-cd: hda: ATAPI 48X DVD-ROM DVD-R CD-R/RW drive, 2048kB Cache
>> Uniform CD-ROM driver Revision: 3.20
>> ide-cd: hdb: ATAPI 40X DVD-ROM DVD-R CD-R/RW drive, 2000kB Cache
>>
>> ata4.01: SATA link up 3.0 Gbps (SStatus 123 SControl 300)
>> ata4.01: HPA detected: current 234439535, native 234441648
>> ata4.01: ATA-7: SAMSUNG HD120IJ, WZ100-33, max UDMA7
>> ata4.01: 234439535 sectors, multi 16: LBA48 NCQ (depth 0/32)
>> ata4.01: configured for UDMA/133
>>
>> ata3.01: SATA link up 3.0 Gbps (SStatus 123 SControl 320)
>> ata3.01: HPA detected: current 976771055, native 976773168
>> ata3.01: ATA-8: WDC WD5000AAKS-22A7B0, 01.03B01, max UDMA/133
>> ata3.01: 976771055 sectors, multi 16: LBA48 NCQ (depth 0/32)
>> ata3.01: configured for UDMA/133
>>
>>
>> # lshw -C disk
>>   *-cdrom:0
>>        description: DVD writer
>>        product: _NEC DVD_RW ND-3500AG
>>        physical id: 0
>>        bus info: [email protected]
>>        logical name: /dev/hda
>>        version: 2.1B
>>        capabilities: packet atapi cdrom removable nonmagnetic dma lba
>> iordy audio cd-r cd-rw dvd dvd-r
>>        configuration: mode=udma2 status=nodisc
>>   *-cdrom:1
>>        description: DVD writer
>>        product: PIONEER DVD-RW DVR-111D
>>        vendor: Pioneer
>>        physical id: 1
>>        bus info: [email protected]
>>        logical name: /dev/hdb
>>        version: 1.19
>>        capabilities: packet atapi cdrom removable nonmagnetic dma lba
>> iordy pm audio cd-r cd-rw dvd dvd-r
>>        configuration: mode=udma4 status=nodisc
>>   *-disk:0
>>        description: ATA Disk
>>        product: WDC WD5000AAKS-2
>>        vendor: Western Digital
>>        physical id: 0
>>        bus info: scsi@2:0.1.0
>>        logical name: /dev/sda
>>        version: 01.0
>>        serial: WD-WMASY3020281
>>        size: 465GiB (500GB)
>>        capabilities: partitioned partitioned:dos
>>        configuration: ansiversion=5 signature=24eeb6a2
>>   *-disk:1
>>        description: ATA Disk
>>        product: SAMSUNG HD120IJ
>>        physical id: 1
>>        bus info: scsi@3:0.1.0
>>        logical name: /dev/sdb
>>        version: WZ10
>>        serial: S0AEJ1LYB06095
>>        size: 111GiB (120GB)
>>        capabilities: partitioned partitioned:dos
>>        configuration: ansiversion=5 signature=a8a8a8a8
>>
>
>



-- 
Üdvözlettel:
Bukuli Norbert