Re: sacrifice H310 hardware r5 for lvm2 raid5+lvmcache

but would OMSA do it and without re-flashing the firmware? 
Or LSI's tool set is needed?

On 27/07/15 14:21, Paul Raines wrote:
>
> I cannot comment on the issue of using the hardware RAID5 
> or not. However, I will say from experience that 1-disk 
> virtual disks are bad idea.  If you are doing that, you 
> should put the disks in JBOD mode instead. Doing a 1-disk 
> vdisk just puts an unnecessarily layer on top of disk I/O 
> that gives a added failure mode for no purpose.
>
> -- Paul Raines (http://help.nmr.mgh.harvard.edu)
>
>
>
> On Mon, 27 Jul 2015 3:48am, lejeczek wrote:
>
>> what do you think?
>>
>> dump raid5? change each pdisk into vdisk exposing to OS and
>> instead run lvm raid5 on those vdisks with a cache device?
>>
>> thanks.
>>
>> _______________________________________________
>> Linux-PowerEdge mailing list
>> [email protected]
>> https://lists.us.dell.com/mailman/listinfo/linux-poweredge
>>
>>
>>
>
>
> The information in this e-mail is intended only for the 
> person to whom it is
> addressed. If you believe this e-mail was sent to you in 
> error and the e-mail
> contains patient information, please contact the Partners 
> Compliance HelpLine at
> http://www.partners.org/complianceline . If the e-mail was 
> sent to you in error
> but does not contain patient information, please contact 
> the sender and properly
> dispose of the e-mail.
>
>