Re: Question about fan speed settings on PowerEdge R720xd

If possible, I'd just like to know the iDRAC settings for "thermal" without
rebooting the machine.

Becky

On Fri, Aug 14, 2015 at 6:30 PM, Becky Ligon <[email protected]> wrote:

> Luke:
>
> I have linux and I have omsa but there is a version mismatch on my
> system.  When I execute racadm, I get the following error message:
>
>
> NOTE:
> The current version of Integrated Dell Remote Access Controller (iDRAC)
> that do not support the execution of RACADM commands.
> Contact Dell customer service to upgrade to iDRAC Express or iDRAC
> Enterprise
> The installed version of RACADM client executable that do not match the
> generation of the server.
>
>
> ===============================================================================
> RACADM version 8.1.0
> Copyright (c) 2003-2013 Dell, Inc.
> All Rights Reserved
>
> ===============================================================================
>
>
> It is telling the truth, the iDRAC version is iDrac7 Enterprise but the
> racadm is 8.1.0.
>
> I can log into the management processor directly.  I get /admin1->
>
> If I enter, racadm, I get racadm>>
>
> When I try to set the fan speed:
>
> racadm>> set System.ThermalSettings.FanSpeedOffset 3
> ERROR: STOR0110 : Invalid Fully Qualified Device Descriptor (FQDD).
> racadm>>
>
> Maybe IDrac7 Enterprise doesn't support changing of the fan speeds?
>
> Becky
>
>
> On Fri, Aug 14, 2015 at 4:41 PM, Luke Pyzowski <[email protected]>
> wrote:
>
>> On linux and omsa installed:
>>
>>
>>
>> /opt/dell/srvadmin/sbin/racadm set System.ThermalSettings.FanSpeedOffset 3
>>
>> /opt/dell/srvadmin/sbin/racadm set System.ThermalSettings.MinimumFanSpeed
>> 100
>>
>>
>>
>>
>>
>> *From:* [email protected] [mailto:
>> [email protected]] *On Behalf Of *Becky Ligon
>> *Sent:* Friday, August 14, 2015 2:36 PM
>> *To:* <[email protected]>
>> *Subject:* [Linux-PowerEdge] Question about fan speed settings on
>> PowerEdge R720xd
>>
>>
>>
>> All:
>>
>> Is it possible to change the fan speeds without bringing down the machine?
>>
>> I have noticed that one of our machines has fan speeds in the 4-5,000 rpm
>> range when all of the others are running between 16-17,000 rpm, and the
>> heat probes indicate a temperature difference as well.
>>
>> Any advice would be appreciated.
>>
>> Becky
>>
>>
>> --
>>
>> Becky Ligon
>> Research Associate
>> Clemson University
>> Clemson, SC
>>
>
>
>
> --
> Becky Ligon
> Research Associate
> Clemson University
> Clemson, SC
>



-- 
Becky Ligon
Research Associate
Clemson University
Clemson, SC

_______________________________________________
Linux-PowerEdge mailing list
[email protected]
https://lists.us.dell.com/mailman/listinfo/linux-poweredge