Re: DSET report on R720 failure
"Stephen Berg (Contractor)" <[email protected]>
| Newsgroups | gmane.linux.hardware.dell.poweredge |
|---|---|
| Message-ID | <Zf7JegNueubbHbQa7Bg2Mg8qoebOH82RHreD43s2uVat2Pj1Wa_tRA@cipher.nrlssc.navy.mil> |
Not a good option for the system in question. I did figure out that an older DSET 3.5.1 seems to run just fine. On 10/08/2015 09:19 AM, Francesco Ciocchetti wrote: > The only time i managed to run the DEST was through the DELL LiveCD > > http://www.dell.com/support/home/us/en/19/Drivers/DriversDetails?driverId=CWF92 > > If you can reboot your box with a livecd it will work. > > > > Francesco Ciocchetti > Senior System Administrator > +44 (0)203 416 4245 > > On 8 October 2015 at 13:08, Stephen Berg (Contractor) < > [email protected]> wrote: > >> Got an R720 running SciLinux 6.6, OMSA 8.2.0 is installed. Trying to >> generate a DSET report so I can have it ready when I call in a failing >> power supply and the DSET tool refuses to run. >> >> --------------------- >> Dell System E-Support Tool, Version 3.7.0 >> @2004-2014 Dell Inc. All Rights Reserved. >> >> sblim-sfcb (CIMOM) validation is not successful. >> >> For successful installation of DSET, reinstall or upgrade sblim-sfcb >> from Operating System Media. >> --------------------- >> >> sblim-sfcb is installed and running >> >> I ran into a similar issue back in May, posted to this list about it but >> never got an answer. >> http://lists.us.dell.com/pipermail/linux-poweredge/2015-May/049782.html >> >> >> -- >> Stephen Berg >> Systems Administrator >> NRL Code: 7320 >> Office: 228-688-5738 >> [email protected] >> >> _______________________________________________ >> Linux-PowerEdge mailing list >> [email protected] >> https://lists.us.dell.com/mailman/listinfo/linux-poweredge >> -- Stephen Berg Systems Administrator NRL Code: 7320 Office: 228-688-5738 [email protected]