iDRAC6 Serial Access to RACADM
Adonis Peralta <[email protected]>
| Newsgroups | gmane.linux.hardware.dell.poweredge |
|---|---|
| Message-ID | <[email protected]> |
For the life of me I can’t figure out how to connect to the iDRAC6 (racadm login) (Im on a Dell R710 - iDRAC6 Enterprise) via the serial port. I go into the bios and have Serial with Console Redirection to COM2. I then Enable RACADM serial via the web gui. I then proceed to try to connect to the COM2 serial port via minicom and I just keep getting nothing. Minicom says not connected - Just a blank screen. I followed the manual and performed the <Esc> + <Shift> <9> command and nothing. I also went into the bios and remove the console redirection so that it’d just say Serial enabled without console redirection. I then set external console port to COM2 and still nothing. Same problem. I am not trying to connect to the serial console (a display of what the OS has). I want to serial into the iDRAC itself so that I can run the racadm commands. Looking at the manual it implies this can be done but nothing I am trying works. Thanks, Adonis _______________________________________________ Linux-PowerEdge mailing list [email protected] https://lists.us.dell.com/mailman/listinfo/linux-poweredge