Re: Linux-gpib-4.2 can not compile on CentoOS 7

Søren Koch via Linux-gpib-general <[email protected]> Wed, 28 Nov 2018 13:52:14 +0100

Newsgroups	gmane.linux.hardware.gpib.general
Message-ID	<[email protected]>

Hi again.


I have just tested on a fresh CentOS7 and the suggested fix works!


Thank you so much for your fast response and help.


Yours

Søren koch


On 11/28/18 11:13 AM, Frank Mori Hess wrote:
> On Tue, Nov 27, 2018 at 11:28 PM Søren Koch via Linux-gpib-general
> <[email protected]> wrote:
>> I have just tried to install linux-gpib-4.2 on a new CentOS 7 system
>> (after running yum update to get latest packages)
>>
>> When I try to compile the kernel driver i get the following error:
>>
> Easiest thing is to go into drivers/gpib/Makefile and disable the
> fmh_gpib driver by removing the line that says
>
> obj-y += fmh_gpib/
>
> Your 3.10 kernel probably needs some extra compatibility code to
> compile the device tree related code in the fmh_gpib driver.  I don't
> think your kernel configuration is wrong.

-- 
Søren Koch
Senior Development Engineer
DTU Energy, Risø Campus
-------------------------------------------
Technical University of Denmark
Department of Energy Conversion and Storage
Frederiksborgvej 399
Building 227, 1.sal
4000 Roskilde
Direct +45 46775816
[email protected]
http://www.ecs.dtu.dk

_______________________________________________
Linux-gpib-general mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/linux-gpib-general

signature.asc (application/pgp-signature, 833 B)