Re: linux-gpib-4.3.0 on Ubuntu 18..04 LTS with multiple NI-GPIB-HS (help please)

Hi Ron,
Your build steps look fine.
To see whether the udev scripts are being run: sudo grep gpib
/var/log/messages
If you do: lsmod | grep gpib
do you see the modules gpib_common and ni_usb_gpib ?
If not there was probably an issue with the build of the kernel modules in
which case please send the kernel module build console log.
cheers,
-Dave

On Tue, 17 Sep 2019 at 08:35, <[email protected]> wrote:

> Greetings,
>
> My apologies in advance for asking a general question. I'm struggling with
> installing linux-gpib-4.3.0 on Ubuntu-18.04LTS and getting a single
> NI-GPIB-HS controller to work (and I need to run two at the same time). Has
> anyone had success doing this? If so, I'm hoping you can help me figure out
> what I'm doing wrong.
>
> I've had linux-gpib-4.2.0 running in the past on Ubuntu 16.04 LTS with a
> single NI-GPIB-HS, but it has been a long time since I set that up, and my
> notes of that installation process aren't the best.
>
> The general outline of what I have done for this 4.3.0 attempt is:
>
> 1) tar -zxvf linux-gpib-4.3.0.tar.gz, and then changed to the created
> directory and performed similar tar operation for the kernel and user files
>
> 2) in the kernel directory: make followed by sudo make install. I saw
> something on the output about SSL errors, but things were created in the
> /lib/modules/kernel_version/gpib directory so I thought I was okay. Maybe
> that is a false assumption
>
> 3) in the user directory: ./configure --sysconfdir=/etc then make followed
> by sudo make install
>
> 4) created the gpib group and added myself to that group
>
> 5) Edited the contents of the 98-gpib-generic.rules file to set the serial
> number for the first NI-GPIB-HS controller
>
> 6) rebooted the computer
>
> I've tried the gpib_config command with the NI-GPIB-HS plugged in, and I
> get the following: failed to open device file '/dev/gpib0'
> main: No such file or directory
>
> I've tried using "udevadm monitor -e"  and I can see when the device gets
> plugged in, but I'm not sure what I should be seeing that shows me that the
> udev rules were processed correctly.
>
> Any suggestions on how to further diagnose what I've done wrong are
> greatly appreciated. If attachments are allowed, I will gladly send the
> contents of the configuration files and the captured output from my attempt
> at monitoring udev.
>
> Regards,
>
> Ron
>
>
> _______________________________________________
> Linux-gpib-general mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/linux-gpib-general
>

_______________________________________________
Linux-gpib-general mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/linux-gpib-general