Help needed
Adrian Scripcă <[email protected]>
| Newsgroups | gmane.linux.hardware.gpib.general |
|---|---|
| Message-ID | <CAC9ou4WGAAtKpCMe2XkA7VxeHobP6S=RCoYThkgqU+MfY6ajpQ@mail.gmail.com> |
Hello all, I am just getting started with linux-gpib and gpib in general and I would require some guidance from more knowledgeable members. Context: I have some HP equipment (HP8656B and a 70000 series SA) which I am trying to communicate with and an Agilent 82357B adapter bought from eBay (most likely a clone but should do). I run a Ubuntu 19.10 distribution with 5.3.0-24-generic kernel so I installed linux-gpib-4.3.0 first. Installation went painlessly. I finally managed to connect to the equipment and issue commands, modifying and querying the state. The next step however is to see whether I can obtain plot data from the spectrum analyzer. So here goes my question: is there a way in which I can emulate a listener with a given address on the GPIB bus and read data while also being connected to the SA and issue commands to it? Sorry if my questions sound confusing but as I mentioned before this is my first interaction with linux-gpib and gpib in general. Thank you, Adrian _______________________________________________ Linux-gpib-general mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/linux-gpib-general