Re: Clone NI GPIB-USB-HS

dave penkler <[email protected]> Sun, 11 Dec 2022 18:34:52 +0100

Newsgroups	gmane.linux.hardware.gpib.general
Message-ID	<CAL=kjP06i5643K7Z75xF=R9UiNETMToXJDYQ5V4dHRz+TQp=NQ@mail.gmail.com>

We have had a number of reports of clones not working with linux-gpib
even though they work under Windows. The main issue that we found is
that they do not work in board mode which *is* required for
linux-gpib.

On Sun, 11 Dec 2022 at 16:36, Michael K via Linux-gpib-general
<[email protected]> wrote:
>
> I'm looking into buying a NI interface (because the Agilent USB device I have can only act as a controller).
> There are many available on eBay that claim to be NI but I suspect are clones.
> Will all clones fail to work on the Linux GPIB driver or is there a chance that it will work?
> thanks,
>   Michael
>
>
> _______________________________________________
> Linux-gpib-general mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/linux-gpib-general