Re: ibcnt reset after ibtmo() call
dave penkler <[email protected]> Mon, 6 Nov 2023 20:40:30 +0100
| Newsgroups | gmane.linux.hardware.gpib.general |
|---|---|
| Message-ID | <CAL=kjP20JxtBKef88TDYGdTu7EXd7gdA+Ghwc1k49HHMVLF5jw@mail.gmail.com> |
Hi Michael, Yes, that is correct. You can use AsyncIbcnt() after ibtmo(). cheers, /d On Mon, 6 Nov 2023 at 18:15, Michael K via Linux-gpib-general < [email protected]> wrote: > I have code that does an async read. > This returns the appropriate ibcnt value. > If I issue an ibtmo() call, the ibcnt is set to 0. > Is this correct behavior? > > > _______________________________________________ > Linux-gpib-general mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/linux-gpib-general > _______________________________________________ Linux-gpib-general mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/linux-gpib-general