RE: compile with ACPI
"Murali Korrapati" <[email protected]>
| Newsgroups | gmane.linux.hardware.sony |
|---|---|
| Message-ID | <[email protected]> |
Well, I looked more into the spec file. It is using the config file in the SOURCES dir. SOURCES has a bunch of config files one for each architecture. So I tried modifying the config file for my arch(i386 I suppose) to turn off APM and on ACPI. Somehow, it is not considering my changes and doing APM. Any ideas? My doubt is, my processor is i686 but the RPM that is being created by rpmbuild is kernelversion.i386.rpm. So I tried modifying the config file for i386 arch. I think it might be looking into some other file, may be i686 config file. Any ideas about this? ~Mur -----Original Message----- From: Jack Coates [mailto:[email protected]] Sent: Saturday, June 28, 2003 1:44 AM To: [email protected] Subject: Re: [Linux-sony] compile with ACPI On Fri, 2003-06-27 at 09:59, Murali Korrapati wrote: > Hi, > I would like to compile a kernel with ACPI turned on to create RPM. I think I have to do > > # rpmbuild -ba -v kernel*.spec > > for this. But I don't know where do I tell to turn on the ACPI. Any Ideas? > > And I have other patches too to apply. I think I should modify the kernel*.spec file > to apply patches. Is this true? > > Thanks. > > ~Mur Yes, you have to modify the spec file. Mandrake has a good page on doing this, search for cooker rpm howto. -- Jack Coates Monkeynoodle: A Scientific Venture... http://www.monkeynoodle.org/resume.html _______________________________________________ Linux-sony mailing list: [email protected] Subscribe/Unsubscribe: http://returntonature.com/mailman/listinfo/linux-sony Linux-Sony Documentation: http://returntonature.com/linux/phpwiki