[tlinux-users:08042] Re: Installs Unsuccessful

Hello folks,

Does anybody know if Conexant will hand in a solution to enable their codecs
for sound/modem? I got sound working by disabling acpi, but then I lost eth1
(no network); I also lost nvidia hardware acceleration, so I had to fall
over to the nv module.

Manuel.


On 8/2/06, Dale Ellis <[email protected]> wrote:
>
> On 7/31/06, Dale Ellis <[email protected]> wrote:
> >
> > On 7/31/06, Carolyn Oates <[email protected]> wrote:
> >
> > > I have had problems with my update install of SUSE
> > > 10.0
> > > BUT SUSE 9.1 worked out of the box (not download -was
> > > new) with no problems...
> > > on both an older Toshiba laptop (about 500mHz) and my
> > > newer Toshiba laptop.
> > >
> > > Hope that helps.
> > > Carolyn
> >
> >
> > I do have an original 9.3 Professional DVD that I can try.  It looks
> > like 9.1 Personal is still available for download.  I'll give them a try
> > tomorrow.
> >
> > Thanks, Carolyn!
> >
> > Dale
> >
> >
> > --- Dale Ellis <[email protected]> wrote:
> > >
> > > > On 7/31/06, Dale Ellis <[email protected]> wrote:
> > > > >
> > > > > On 7/31/06, Harvey Goldberg < [email protected]>
> > > > wrote:
> > > > >
> > > > > > Did you run the media check on the Boot/Install
> > > > media?  I had Problems
> > > > > with a bad Burn and the install would not
> > > > complete.  Also, Make sure you set
> > > > > the USB in BIOS not to use legacy emulation. I
> > > > have a A65 P4,1GB, 3.2ghzetc, I got everything to
> > > > function on it with DapperDrake and got almost
> > > > > Everything (PCMCIA prob) on SUSE 10.1 FYI... i ran
> > > > the install and left
> > > > > the room during the install because it looked like
> > > > nothing was happening,
> > > > > in other words be patient during the install.
> > > > >
> > > > >
> > > > > On 7/30/06, Dale Ellis <[email protected] >
> > > > wrote:
> > > > > >
> > > > > >
> > > > > > I have not been successful in any of my attempts
> > > > to install several
> > > > > > Linux distros in my Toshiba M45 S265 laptop.
> > > > > >
> > > > >
> > > > > I have tried two or more copies of install media,
> > > > and verified MD5 on
> > > > > all.  I have not changed any of the BIOS settings
> > > > you mentioned.  Both
> > > > > legacy USB settings were enabled -- now disabled.
> > > > I'll try install again.
> > > > > Thanks.
> > > > >
> > > > > Dale
> > > > >
> > > >
> > > >
> > > > Disabling the legacy USB settings had ne effect on
> > > > the problem.
> > > >
> > > > Dale
> > >
> >
> >
> >
> To one and all....
>
> At last I've found a solution to my install problem -- at least with SuSE
> 10.0.  I found that IRQ 10 was being disabled during boot for reasons I
> haven't identified.  When installing with ACPI active, two USB ports and my
> sound module were being assigned to IRQ 10.  I found the sequence of IRQ
> assignments in "/var/log/messages", as well as a notation to try "irqpoll"
> as a boot parameter.  By adding this to "/boot/grub/menu.lst" my problem
> with sound and USB was solved.
>
> It looks like recent Linux kernels and my Toshiba can't play nice without
> this work-around.  Not sure why, but I'm now a happy camper.
>
> Dale
>