Re: Heartbeat fails to start any resources in haresources

Andersson Mattias <mattias.andersson <at> smhi.se> writes:

> 
> As far as I can see you only have one node configured in your cluster.
> I can't recall actually read it somewhere but I am quite certain
> heartbeat
> will not run with only one node(at least not heartbeat 1), and I don't
> think it will complain either, it will simply just not work. It doesn't
> make much sense running a one node cluster, does it? Well, if you only
> want to play around a little you can foul heartbeat and configure an
> other imaginary node in you config. 
> 
> When you have fixed this notice that you have a quite long initdead-time
> to, and hearbeat does not start your resources until that time have
> elapsed or all nodes are up so that they can decide the preferred master
> should have them.


Ahh, I added another node and everything works as expected.

I also changed my initdead-time as you suggested. 

many thanks, I was really stuck there.
-m




-- 
Ultra Monkey - http://www.ultramonkey.org/
To UNSUBSCRIBE, email to [email protected], with a body:
unsubscribe ultramonkey-users [email protected]
where "[email protected]" is YOUR email address.