Re: run command after failover

Thanks Simon, can you refer me to any website on how to create that script?

Simon Horman wrote:
> On Tue, Dec 30, 2008 at 08:15:31AM +0800, Ron wrote:
>> Hi,
>>
>> I'm using heartbeat to do failover for my asterisk, i binded the 
>> asterisk on the virtual IP, coz for some reason it does not work 
>> properly if binded to 0.0.0.0.
>>
>> my question would be, if the master fails, virtual ip will go to slave, 
>> i need to run asterisk on the slave so that it can be binded to the 
>> virtual IP. how can i run the asterisk daemon when the slave takes over?
> 
> Hi Ron,
> 
> There are several different ways of solving this problem.
> One is to have bouth the VIP and asterisk managed by linux-ha (heartbeat).
> 
> Linux-HA manages resources. And it should be pretty easy to
> turn asterisk into a resource by writing a resource-script for it -
> something like an init script, but a bit different. That is, if one
> doesn't already exist. linux-ha.org should have information on
> how to do this. If you can't find it, let me know.
> 
_______________________________________________
Ultramonkey-users mailing list
[email protected]
http://lists.vergenet.net/listinfo/ultramonkey-users