Re: Installation problems

Hello Rick,

You are correct, I only have one entry for my VIP's on each node as 
well. For node 1 I use LVS1 as the node name and on node 2 I use LVS2 as 
the node name in haresources. The VIP entries are the same, but the node 
names change to their repective node name within haresources.

What I noticed about Robert's haresources file was that node names were 
not present before the VIPs (node_name IPaddr2::....).

Simone.

Rick Willmore wrote:

>My config (haresources) only has a single entry in each of the servers
>and according to the LVS Tutorial it only has 1 entry as well.. Is there
>a more complex setup requiring both the entries listed below ??
>
>R. 
>
>-----Original Message-----
>From: [email protected]
>[mailto:[email protected]] On Behalf Of Simone
>Segato
>Sent: Thursday, August 11, 2005 2:07 PM
>To: [email protected]
>Subject: Re: Installation problems
>
>Hello Robert,
>
>In your haresources file on both nodes try this:
>
>On LVS1 put this in haresources
>lvs1.daedulussoftware.com   IPaddr2::192.168.0.100/24/eth0 \
> 
>IPaddr2::192.168.0.200/24/eth0
>LVS2 put this in haresources
>lvs2.daedulussoftware.com   IPaddr2::192.168.0.100/24/eth0 \
> 
>IPaddr2::192.168.0.200/24/eth0
>
>Let me know how that turns out.
>Simone.
>
>  
>
>  
>


-- 
Ultra Monkey - http://www.ultramonkey.org/
To UNSUBSCRIBE, email to [email protected], with a body:
unsubscribe ultramonkey-users [email protected]
where "[email protected]" is YOUR email address.