Re: Need help to run UM3

Hi, Horms,
Thanks for your prompt response.  Here are the files requested.  Similar
configuration had not problems to run on UM2.01.  dmccm1 is the output of
uname -n.

Lin Wang

ha.cf
-------------------------------------------------------------------
logfile     /var/log/ha-log
keepalive 2
deadtime 30
warntime 10
initdead 120
udpport 649
bcast eth1
auto_failback on
node  dmccm1
node  dmccm2
ping x.x.x.1
respawn hacluster /usr/lib/heartbeat/ipfail
#respawn haclient /usr/lib/heartbeat/ccm
#apiauth ipfail uid=hacluster
--------------------------------------

haresources
------------------------------------
dmccm1 IPaddr2::x.x.x.25/23/eth0/x.x.x.255 ldirectord::ldirectord.cf
LVSSyncDaemonSwap::master
dmccm1 IPaddr2::x.x.x.51/23/eth0/x.x.x.255 ldirectord::ldirectord.cf
LVSSyncDaemonSwap::master
dmccm1 IPaddr2::x.x.x.52/23/eth0/x.x.x.255 ldirectord::ldirectord.cf
LVSSyncDaemonSwap::master
dmccm1 IPaddr2::x.x.x.53/23/eth0/x.x.x.255 ldirectord::ldirectord.cf
LVSSyncDaemonSwap::master






                                                                           
             Horms                                                         
             <[email protected].                                             
             au>                                                        To 
             Sent by:                  [email protected]   
             ultramonkey-users                                          cc 
             -owner@ultramonke                                             
             y.org                                                 Subject 
                                       Re: Need help to run UM3            
                                                                           
             10/27/2005 12:18                                              
             PM                                                            
                                                                           
                                                                           
             Please respond to                                             
             ultramonkey-users                                             
             @ultramonkey.org                                              
                                                                           
                                                                           




On Thu, Oct 27, 2005 at 10:32:55AM -0400, Lin Wang wrote:
>
>
> I am not an expert on Linux, but managed to make UM2.01 work on rh3 for
two
> years.  I recently upgraded to UM3 with rh kernel and got into trouble.
> Basically, HA dies on startup and report error "Cannot locate resource
> script dmccm1".  I reinstalled everything and got the same result.  I
must
> have missed something here and need help.  I am using advanced high
> availability and load balancing and have two Linux directors, dmccm1 and
> dmccm2.  The following shown in the log on dmccm1 which is the primary:

Could you please send your ha.cf and haresources files?


--
Ultra Monkey - http://www.ultramonkey.org/
To UNSUBSCRIBE, email to [email protected], with a body:
unsubscribe ultramonkey-users [email protected]
where "[email protected]" is YOUR email address.