Re: multiple ultramonkeys
Horms <[email protected]>
| Newsgroups | gmane.linux.highavailability.ultramonkey |
|---|---|
| Message-ID | <[email protected]> |
Mark Brosius <[email protected]> wrote: > I was able to get the document that is stored on RealServer3 and > RealServer4 using two different UltraMonkey machines with each UltraMonkey > on a different network 172.16.X.0 and 172.16.Y.0. My new challenge is to > use only one UltraMonkey machine (172.16.X.10) to load balance between > RealServer1 (172.16.X.1) and RealServer2 (172.16.X.2) then redirect that > traffic to the same Ultramonkey (172.16.X.10) machine which will then load > balance between RealServer3 (172.16.X.3) and RealServer4 (172.16.X.4). Is > this possible? I am having problems (I get a bad gateway error) and I > can't determine if it is a network issue or an UltraMonkey limitation. It is most likely a networking problem. Try using tcpdump or something similar to observe what is going on. -- Horms -- Ultra Monkey - http://www.ultramonkey.org/ To UNSUBSCRIBE, email to [email protected], with a body: unsubscribe ultramonkey-users [email protected] where "[email protected]" is YOUR email address.