Re: Failover query (not exactly an Ultra Monkey issue)

Vic Berdin <[email protected]> wrote:
> Hi,
> 
> I'm doing LVS/HA Direct Routing using two old Linux-2.4.x boxes. My arp
> block is implemented using the old "noarp" module. High Availability with
> heartbeat and load balancing with ldirectord works well. Failover works ok
> at some point. But what I wish to resolve with my setup are the unwanted
> failovers.
> 
> The scenario is like this, once the current (default/configured) Master node
> goes down, and the Secondary node takes over, the default Master node that
> went down will still tend to grab Directorship status from the already
> (currently) running Master node. This unwanted failover happens within a
> _still_undetermined_ period after the newly raised node re-joins the
> cluster. Sometimes this failover happens almost immediately, sometimes after
> many hours (even after a few days) of run time.

Have you tried setting auto_failback off
in /etc/ha.d/ha.cf ?

-- 
Horms


-- 
Ultra Monkey - http://www.ultramonkey.org/
To UNSUBSCRIBE, email to [email protected], with a body:
unsubscribe ultramonkey-users [email protected]
where "[email protected]" is YOUR email address.