Re: 3 Server solution

Your configuration is more like this one than the one you mention:

http://www.ultramonkey.org/3/topologies/sl-ha-lb-overview.html

In essence though, after a quick look at your config files, you  
should probably use 'gate' mode rather than 'masq'.

> Hello All,
>
> I have 3 servers in total, and want to use one of the servers as a  
> dedicated director server and one as director fail over and real  
> server, third will be the dedicated real server. The documentation  
> is related to 4 servers (two directors and two real servers)
>
> http://www.ultramonkey.org/3/topologies/ha-lb-eg.html
>
> in addition I have only one ethernet card on each machine. Hence  
> all machines are on the same network.
>
> I have attempted to follow the above mentioned documentation but  
> here is what is happening.
>
> the heartbeat starts fine on the primary director and backup  
> director, the VIP gets setup fine, but when I send a request to the  
> VIP the fallback IP is used and on issuing the command /sbin/ 
> ipvsadm -L -n indicates only the 127.0.0.1 is up and the actual  
> real servers are down.
>
> I have attached all the configuration files that I altered.
>
> Can anyone please suggest a documentation related to a setup  
> similar to mine or where should I look to get some more help.
>
> I am doing this for the first time so havent got much clue about  
> how to setup loadbalancing and failover services.
>
> Any help would be  a blessing,
>
> Thanks a lot,
>
> Imran.
>
> <ldirectord.cf>
> <haresources>
> <authkeys>
> <ha.cf>


-- 
Ultra Monkey - http://www.ultramonkey.org/
To UNSUBSCRIBE, email to [email protected], with a body:
unsubscribe ultramonkey-users [email protected]
where "[email protected]" is YOUR email address.