arptables on slave not get released, pls help!!! urgent!!!
Jiang <[email protected]>
| Newsgroups | gmane.linux.highavailability.ultramonkey |
|---|---|
| Message-ID | <[email protected]> |
Hi,
I just got a very weird problem, when stop heartbeat on master to
force failover to slave, slave is able to take up all my virtual IPs,
but I lost all the connections to the VIPs. I checked arptables -L -v
-n, it is still showing:
********************************************************************
Chain IN (policy ACCEPT 230 packets, 6440 bytes)
pkts bytes target in out source-ip
destination-ip source-hw destination-hw hlen op
hrd pro
10 280 DROP * * 0.0.0.0/0
10.226.200.210 00/00 00/00 any
0000/0000 0000/0000 0000/0000
10 280 DROP * * 0.0.0.0/0
10.226.200.220 00/00 00/00 any
0000/0000 0000/0000 0000/0000
Chain OUT (policy ACCEPT 37 packets, 1036 bytes)
pkts bytes target in out source-ip
destination-ip source-hw destination-hw hlen op
hrd pro
0 0 mangle * bond0 10.226.200.210 0.0.0.0/0
00/00 00/00 any 0000/0000
0000/0000 0000/0000 --mangle-ip-s 10.226.200.213
0 0 mangle * eth0 10.226.200.210 0.0.0.0/0
00/00 00/00 any 0000/0000
0000/0000 0000/0000 --mangle-ip-s 10.226.200.213
0 0 mangle * eth1 10.226.200.210 0.0.0.0/0
00/00 00/00 any 0000/0000
0000/0000 0000/0000 --mangle-ip-s 172.16.1.20
0 0 mangle * eth2 10.226.200.210 0.0.0.0/0
00/00 00/00 any 0000/0000
0000/0000 0000/0000 --mangle-ip-s 10.226.200.213
0 0 mangle * eth3 10.226.200.210 0.0.0.0/0
00/00 00/00 any 0000/0000
0000/0000 0000/0000 --mangle-ip-s 172.16.1.20
0 0 mangle * bond1 10.226.200.210 0.0.0.0/0
00/00 00/00 any 0000/0000
0000/0000 0000/0000 --mangle-ip-s 172.16.1.20
0 0 mangle * bond0 10.226.200.220 0.0.0.0/0
00/00 00/00 any 0000/0000
0000/0000 0000/0000 --mangle-ip-s 10.226.200.213
0 0 mangle * eth0 10.226.200.220 0.0.0.0/0
00/00 00/00 any 0000/0000
0000/0000 0000/0000 --mangle-ip-s 10.226.200.213
0 0 mangle * eth1 10.226.200.220 0.0.0.0/0
00/00 00/00 any 0000/0000
0000/0000 0000/0000 --mangle-ip-s 172.16.1.20
0 0 mangle * eth2 10.226.200.220 0.0.0.0/0
00/00 00/00 any 0000/0000
0000/0000 0000/0000 --mangle-ip-s 10.226.200.213
0 0 mangle * eth3 10.226.200.220 0.0.0.0/0
00/00 00/00 any 0000/0000
0000/0000 0000/0000 --mangle-ip-s 172.16.1.20
0 0 mangle * bond1 10.226.200.220 0.0.0.0/0
00/00 00/00 any 0000/0000
0000/0000 0000/0000 --mangle-ip-s 172.16.1.20
*********************************************************************
By right it should release all these policies.
What could be wrong to have this kind of problem?
Urgent!! Pls help!! Your help is highly appreciated!
--
Regards,
Jiang
--
Ultra Monkey - http://www.ultramonkey.org/
To UNSUBSCRIBE, email to [email protected], with a body:
unsubscribe ultramonkey-users [email protected]
where "[email protected]" is YOUR email address.