[RFC Patch V1 13/30] mm, i40e: Use cpu_to_mem()/numa_mem_id() to support memoryless node

When CONFIG_HAVE_MEMORYLESS_NODES is enabled, cpu_to_node()/numa_node_id()
may return a node without memory, and later cause system failure/panic
when calling kmalloc_node() and friends with returned node id.
So use cpu_to_mem()/numa_mem_id() instead to get the nearest node with
memory for the/current cpu.

If CONFIG_HAVE_MEMORYLESS_NODES is disabled, cpu_to_mem()/numa_mem_id()
is the same as cpu_to_node()/numa_node_id().

Signed-off-by: Jiang Liu <[email protected]>
---
 drivers/net/ethernet/intel/i40e/i40e_txrx.c |    2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/intel/i40e/i40e_txrx.c b/drivers/net/ethernet/intel/i40e/i40e_txrx.c
index e49f31dbd5d8..e9f6f9efd944 100644
--- a/drivers/net/ethernet/intel/i40e/i40e_txrx.c
+++ b/drivers/net/ethernet/intel/i40e/i40e_txrx.c
@@ -1342,7 +1342,7 @@ static int i40e_clean_rx_irq(struct i40e_ring *rx_ring, int budget)
 	unsigned int total_rx_bytes = 0, total_rx_packets = 0;
 	u16 rx_packet_len, rx_header_len, rx_sph, rx_hbo;
 	u16 cleaned_count = I40E_DESC_UNUSED(rx_ring);
-	const int current_node = numa_node_id();
+	const int current_node = numa_mem_id();
 	struct i40e_vsi *vsi = rx_ring->vsi;
 	u16 i = rx_ring->next_to_clean;
 	union i40e_rx_desc *rx_desc;
-- 
1.7.10.4

--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to [email protected].  For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"[email protected]"> [email protected] </a>