[RFC Patch V1 15/30] mm, igb: Use cpu_to_mem()/numa_mem_id() to support memoryless node

When CONFIG_HAVE_MEMORYLESS_NODES is enabled, cpu_to_node()/numa_node_id()
may return a node without memory, and later cause system failure/panic
when calling kmalloc_node() and friends with returned node id.
So use cpu_to_mem()/numa_mem_id() instead to get the nearest node with
memory for the/current cpu.

If CONFIG_HAVE_MEMORYLESS_NODES is disabled, cpu_to_mem()/numa_mem_id()
is the same as cpu_to_node()/numa_node_id().

Signed-off-by: Jiang Liu <[email protected]>
---
 drivers/net/ethernet/intel/igb/igb_main.c |    4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/intel/igb/igb_main.c b/drivers/net/ethernet/intel/igb/igb_main.c
index f145adbb55ac..2b74bffa5648 100644
--- a/drivers/net/ethernet/intel/igb/igb_main.c
+++ b/drivers/net/ethernet/intel/igb/igb_main.c
@@ -6518,7 +6518,7 @@ static bool igb_can_reuse_rx_page(struct igb_rx_buffer *rx_buffer,
 				  unsigned int truesize)
 {
 	/* avoid re-using remote pages */
-	if (unlikely(page_to_nid(page) != numa_node_id()))
+	if (unlikely(page_to_nid(page) != numa_mem_id()))
 		return false;
 
 #if (PAGE_SIZE < 8192)
@@ -6588,7 +6588,7 @@ static bool igb_add_rx_frag(struct igb_ring *rx_ring,
 		memcpy(__skb_put(skb, size), va, ALIGN(size, sizeof(long)));
 
 		/* we can reuse buffer as-is, just make sure it is local */
-		if (likely(page_to_nid(page) == numa_node_id()))
+		if (likely(page_to_nid(page) == numa_mem_id()))
 			return true;
 
 		/* this page cannot be reused so discard it */
-- 
1.7.10.4

--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to [email protected].  For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"[email protected]"> [email protected] </a>