Re: [RFC Patch V1 21/30] mm, irqchip: Use cpu_to_mem()/numa_mem_id() to support memoryless node

On Fri, Jul 11, 2014 at 03:37:38PM +0800, Jiang Liu wrote:
> When CONFIG_HAVE_MEMORYLESS_NODES is enabled, cpu_to_node()/numa_node_id()
> may return a node without memory, and later cause system failure/panic
> when calling kmalloc_node() and friends with returned node id.
> So use cpu_to_mem()/numa_mem_id() instead to get the nearest node with
> memory for the/current cpu.
> 
> If CONFIG_HAVE_MEMORYLESS_NODES is disabled, cpu_to_mem()/numa_mem_id()
> is the same as cpu_to_node()/numa_node_id().
> 
> Signed-off-by: Jiang Liu <[email protected]>
> ---
>  drivers/irqchip/irq-clps711x.c |    2 +-
>  drivers/irqchip/irq-gic.c      |    2 +-
>  2 files changed, 2 insertions(+), 2 deletions(-)

Do you have anything depending on this?  Can apply it to irqchip?  If
you need to keep it with other changes,

Acked-by: Jason Cooper <[email protected]>

But please do let me know if I can take it.

thx,

Jason.

--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to [email protected].  For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"[email protected]"> [email protected] </a>