(usagi-users 03418) DAD Transmit question

"Chris Nassar" <[email protected]>
Newsgroups gmane.linux.ipv6.usagi.users
Message-ID <[email protected]> 
Hi

 

I'm running the TAHI conformance test, specifically the ipv6 ready phase
one stateless address configuration test. I'm running linux 2.4.26 with
the usagi-linux24-s20040621-2.4.26.diff patch.  The only way I can get
the tests to pass is to change the net.ipv6.conf.eth0.dad_transmits
variable to 3 or greater. Can anyone tell me why this would be the case
and why it wouldn't work on just the default value of 1? Are there any
ill effects by changing that variable to a higher number?

 

Thank you in advance,

Chris
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.