(usagi-users 03586) phase2- automatic testing -- on linux 2.6

		Hi.everyone..


         


		I am trying to run automatic testing for
ipv6Ready-Phase2-logo...
		I kept my Redhat Linux 2.6-USAGI -kernel as NUT and
FreeBSD 4.11Release  as a TN.....
		The  problem here is I cannot able to connect with my
NUT ( Redhat  Linux 2.6-USAGI-kernel ) using  cu -l /dev/cuaa0 -s 9600
command from TN ...
		But the same command is working fine with Redhat  Linux
2.4--kernel  as a NUT  without any problem....

		Before building  Linux 2.6-USAGI -kernel  I installed
the following things on my NUT
		1.I installed module-init-tools before I do kernel
compilation and also I am having latest version of glibc.....
		2.since my NUT boot file is lilo, i made changes to
lilo.conf file(added console =ttyS0,9600n8) which is same in (Redhat
Linux 2.4--kernel  ) but creating problem only while booting  Redhat
Linux 2.6-USAGI-kernel ...i.e I cant able capture boot process on my
TN...
		I don't know the reason....

		Expecting  your valueable reply..
		Regds
		Vishal


      
 Additional information needs to be updated in  INSTALL.txt file IN TAHI
as per as our experience.

 
                CU command which is a part of UUCP package will work on
4.11 BSD
                Only  if UUCP version -1.07 -freebsd or higher is
present .
                CU command will not work with uucp-1.06

                 UNTIL WE TRACE THIS PROBLEM WE COULD NOT ABLE TO RUN CU
COMMAND