(usagi-users 03660) Problems with stateless autoconf tests ...

Hi!

I tried to run the IPv6ready test suite for Phase 1 (from TAHI) on a 
Usage Kernel 2.6.15 (snapshot 2006/03/27 IIRC). Everything went fine 
until it started to go into the Stateless Autoconfiguration section, 
where all tests I tried out failed  (well, I stopped after test 4).

It says:

reboot_async.rmt returned status 0
*** Target testing phase ***
Clear Captured Packets (Link0)
TN received no DAD NS sent from NUT. It seems that NUT doesn't perform DAD process.
Wait 5 second
Check if NUT's address is configured
Send DAD NS from TN to NUT: DADNS_from_TN_SameTgt
send DADNS_from_TN_SameTgt
Wait DAD NA from NUT: DADNA_from_NUT,DADNA_from_NUT_woTLL
recv DADNA_from_NUT
Received packet count=1
Received DAD NA from NUT: DADNA_from_NUT
NUT assigned the address to the interface.
Without DAD, NUT assigned the address to the interface.
NG
*** EOT ***
  -> FAIL


I am pretty sure this is a configuration issue. What kind of 
configuration do I have to set up in order to pass these tests?

Thanks in advance,
kind regards,
Heiko