(usagi-users 03820) mip6d-daemon multiple interfaces

 Hi,

I loaded mipv6-demon and there is a problem with the content of file
configuration (mip6d.conf) on mobile node side (MN) :

With only one interface written into the file there is no problem. But when
I add an other interface (eth1) with a preference on eth0 in the mip6d.conf,
there is a kernel oops in the following situations:

- If the home address are different on each interface, when i stop mipl
there is a kernel oops.

- if the home address for the both interface is the same, a kernel oops
appears after sending some BUs.

Here is the mip6d.conf file:

# This is an example of 2Imip6d Mobile Node configuration file

NodeConfig MN;

## If set to > 0, will not detach from tty

DebugLevel 10;

## Support route optimization with other MNs

DoRouteOptimizationCN disabled;

## Use route optimization with CNs

DoRouteOptimizationMN disabled;

UseCnBuAck disabled;

#MnUseAllInterfaces = enabled;

Interface "eth0" {

MnIfPreference 1;

}

Interface "eth1" {

MnIfPreference 2 ;

}

MnHomeLink "eth0" {

HomeAgentAddress 2001:688:aa00::1 ;

HomeAddress 2001:688:aa00::2002/64 ;

}

MnHomeLink "eth1" {

HomeAgentAddress 2001:688:aa00::1;

HomeAddress 2001:688:aa00::2002/64 ;

}

There is no ploblem with mipl release 2.0.2

Thank for your help


-- 
echo '[q]sa[ln0=aln256%Pln256/snlbx]sb3135071790101768542287578439snlbxq'|dc


-- 
echo '[q]sa[ln0=aln256%Pln256/snlbx]sb3135071790101768542287578439snlbxq'|dc