(usagi-users 04010) Re: Questions regarding the operation of MIPv6

Luis Campo Giralte <[email protected]> Tue, 18 Dec 2007 07:29:42 +0100
Newsgroups gmane.linux.ipv6.usagi.users
Message-ID <[email protected]>
El lun, 17-12-2007 a las 18:24 -0500, Ryan Measel escribi=C3=B3:
> 1. When a network is encrypted, are the router advertisements also encr=
ypted?
>=20
router advertisements only advertise a router, there is no sense to
encrypt them, any way if you want to use other methods use dhcpv6,
router advertisements its basic.

> 2. How does a mobile node migrate into an encrypted network?
>=20
in the same way that does to a non encrypted network.

> 3.  I understand router advertisements are sent out to a multicast
> address periodically by routers or they may be solicited by a node.
> The node can then act on a received RA and migrate to that network.
> How does this work if the router is on a different channel?  Does the
> mobile node scan the channels?

channels are on the link layer, routers advertisements on the network.

>=20
> 4.  I have been done some testing.  For a hundred trials between two
> wireless networks, it took an average of 5.5s longer for handovers to
> occur with IPSec enabled than with it disabled.  What would account
> for this added delay?  IPSec encapsulates the tunnel traffic, but is
> there some added process or handshake that occurs?
>=20
the handovers not depend on if you use IPSec.

I recomend you to read more carefully the rfcs or other docs because i
think all that questions you said are respond on the rfcs, any way o
hope i help you with them ;)

Regards Luis

> Thanks for your help.
>=20
> Cheers,
> Ryan
>=20
>=20
--=20
Luis Campo Giralte     e-mail: [email protected]
TELEF=C3=93NICA INVESTIGACI=C3=93N Y DESARROLLO                          =
       =20
Protocolos y Nucleos de Red    =20
C/ Emilio Vargas 6 - 28043 Madrid - Spain