[PATCH] mISDN: Bugfix for layer2 fixed TEI mode
Karsten Keil <[email protected]>
| Newsgroups | gmane.linux.network,gmane.linux.kernel.stable,gmane.linux.isdn.i4l.user |
|---|---|
| Message-ID | <[email protected]> |
If a fixed TEI is used, the initial state of the layer 2 statmachine need to be 4 (TEI assigned). This was true only for Point to Point connections, but not for the other fixed TEIs. It was not found before, because usually only the TEI 0 is used as fixed TEI for PtP mode, but if you try X31 packet mode connections with SAPI 16, TEI 1, it did fail. Signed-off-by: Karsten Keil <[email protected]> Cc: <[email protected]> # 3.5.x --- drivers/isdn/mISDN/layer2.c | 2 +- 1 files changed, 1 insertions(+), 1 deletions(-) diff --git a/drivers/isdn/mISDN/layer2.c b/drivers/isdn/mISDN/layer2.c index 0dc8abc..949cabb 100644 --- a/drivers/isdn/mISDN/layer2.c +++ b/drivers/isdn/mISDN/layer2.c @@ -2222,7 +2222,7 @@ create_l2(struct mISDNchannel *ch, u_int protocol, u_long options, int tei, InitWin(l2); l2->l2m.fsm = &l2fsm; if (test_bit(FLG_LAPB, &l2->flag) || - test_bit(FLG_PTP, &l2->flag) || + test_bit(FLG_FIXED_TEI, &l2->flag) || test_bit(FLG_LAPD_NET, &l2->flag)) l2->l2m.state = ST_L2_4; else -- 1.7.7