Re: "MPH_DEACTIVATE_IND" message.... (now with single port HFC board)

Am 25.03.2014 10:07, schrieb fabio antonini:
> Hi Doug
> I have a scenario not far from yours and I'm facing the same problem.
> I have a 4 channels cologne evalboard based on XHFC_4SU
> 
> ~ # misdn_info
> 
> Found 4 ports
>   Port  0 'XHFC.1':          TE/NT-mode BRI S/T (for phone lines & phones)
>                               2 B-channels: 1-2
>                                 B-protocols: RAW HDLC X75slp L2:DSP
> L2:DSPHDLC
>   --------
>   Port  1 'XHFC.2':          TE/NT-mode BRI S/T (for phone lines & phones)
>                               2 B-channels: 1-2
>                                 B-protocols: RAW HDLC X75slp L2:DSP
> L2:DSPHDLC
>   --------
>   Port  2 'XHFC.3':          TE/NT-mode BRI S/T (for phone lines & phones)
>                               2 B-channels: 1-2
>                                 B-protocols: RAW HDLC X75slp L2:DSP
> L2:DSPHDLC
>   --------
>   Port  3 'XHFC.4':          TE/NT-mode BRI S/T (for phone lines & phones)
>                               2 B-channels: 1-2
>                                 B-protocols: RAW HDLC X75slp L2:DSP
> L2:DSPHDLC
> 
> I have connected the first channel (TE mode) to an external equipment
> (working fine for sure) configured as NT.
> 

Does this be a P2P or P2MP type of line ? misdntestcon only works for
P2MP lines.
You should try misdntestlayer3 -P for P2P lines.

Karsten