Re: "MPH_DEACTIVATE_IND" message.... (now with single port HFC board)

Hi Karsten,
I executed the way you wanted to test the PTP channel, through
misdntestlayer3.

Can you please tell me, if this output is normal?!
I see everywhere this output: "but not ....."

What does it tell me?!




Doug




mISDNInfo:

Found 1 port
  Port  0 'hfc-pci.1':       TE/NT-mode BRI S/T (for phone lines & phones)
                              2 B-channels: 1-2
                                B-protocols: RAW HDLC X75slp L2:DSP
L2:DSPHDLC



misdntestlayer3:

doug@home:/tmp# misdntestlayer3 -T 50 -P -c 0 -n 1234 -v 5 -f 0


mISDN Test L3 2.0
27.03.2014 01:52:34.092054  TestmISDN cannot open test_file.out due to
No such file or directory
27.03.2014 01:52:34.092174  mISDN kernel version 1.01.29 found
27.03.2014 01:52:34.092200  mISDN user   version 1.01.31 found
27.03.2014 01:52:34.092221  mISDN library interface version 2 release 5
27.03.2014 01:52:34.092507  open card 0 with 2 channels options(50003)
27.03.2014 01:52:41.107420  from L3 cmd MPH_DEACTIVATE_IND (602) pid(10000)
27.03.2014 01:52:41.107468  got message (602) with pid(10000) but not
ff008001
27.03.2014 01:52:41.107505  from L3 cmd FREE_PID (11001) pid(ff008001)
27.03.2014 01:52:41.107548  from L3 cmd L2IDLE (12002) pid(0)
27.03.2014 01:52:41.107570  got message (12002) with pid(0) but not ffffffff
27.03.2014 01:52:41.107621  from L3 cmd L2RELEASE (12001) pid(0)
27.03.2014 01:52:41.107645  got message (12001) with pid(0) but not ffffffff
27.03.2014 01:52:41.107566  control pipe unhandeld cmd 11001 - FREE_PID
27.03.2014 01:52:41.107711  Worker terminated with 0