Re: [PATCH 3/4] tty: allow tty drivers to rename their device nodes

On Wed, May 28, 2014 at 11:06:41PM +0200, Paul Bolle wrote:
> On Wed, 2014-05-28 at 13:56 -0700, Greg Kroah-Hartman wrote:
> > On Wed, May 21, 2014 at 11:39:26PM +0200, Tilman Schmidt wrote:
> > > From: Paul Bolle <[email protected]>
> >>
> > > The device nodes for tty drivers are named using a straightforward
> > > scheme: tty_driver->name with an (increasing) digit appended. But the
> > > capi driver (a part of one of the current ISDN subsystems) requires a
> > > different naming scheme for its "capi_nc" tty_driver:
> > >     /dev/capi/0
> > >     /dev/capi/1
> > >     [...]
> > 
> > Can't you just use a '!' character to represent the '/' and the tty core
> > will handle it all properly for you without this tty core change needed?
> 
> As in: set struct tty_driver.name to "capi!"?

Yes.  Try it and see :)

If not, let me know, it should "just work".

> > > So add a devnode() callback to struct tty_driver to allow tty drivers
> > > to use a more elaborate naming scheme. And let tty_devnode(), the
> > > devnode() callback for the "tty" class, call that new callback if a tty
> > > driver uses one. This allows the capi driver to add a callback to
> > > enable its scheme.
> > 
> > And why the sudden need for this feature, what changed in isdn to
> > warrant this change?
> 
> Did you already read the explanation to 4/4? It contains a summary of
> the events that got us in the current situation.

Sorry, only read patch 3 as it came first :)

But try the above first, the driver core and udev supports the '!'
character for subdirs for a very long time thanks to some horrid scsi
drivers needing it...

thanks,

greg k-h