1.2.7 Vrrp not remove virtual interface when receive termination signal

Hi,

I'm using keepalived vrrp on my project. I compiled keepalived with --vrrp 
option and kernel supports vmac feature.

When I run keepalived binary, it creates a virtual interface and assigns ip 
and vmac addresses(when state MASTER) as I configured. But when I kill(killall 
<processname>) keepalived process, sometimes it cannot remove virtual 
interfaces, and if I start keepalived in this stiuation, it adds virtual ip to 
real eth device as a second ip address. 

As I saw in detail logs, vrrp receives SIGTERM signal but sometimes not remove 
virtual interface. Is this a normal behaviour of vrrp? If not, will a patch or 
new version of keepealived be release? 





Thanks,



------------------------------------------------------------------------------
This SF.net email is sponsored by Windows:

Build for Windows Store.

http://p.sf.net/sfu/windows-dev2dev