Keepalived ipv6 virtual ip address is wrong

Im using keepalived 1.2.10 version for my project. When I run keepalived 
deamon with ipv4 and ipv6 virtual addresses, keepalived works fine, but when 
I capture vrrp packets with wireshark, I saw that "0.0.0.0" is written 
instead of ipv6 vip on ip address segment of vrrp packet. 

Also if I force to use ipv6, ip address segment of vrrp packet will be empty 
and wireshark warns to wrong packet.  

Then I realized, hd->naddr shows all vips count but it is false, because it 
must be show only ipv4 vips or ipv6 vips count. So that "0.0.0.0" is written 
instead of ipv6 address. 

Is this a bug? If yes, when will new version be released?


Thanks,



------------------------------------------------------------------------------
Flow-based real-time traffic analytics software. Cisco certified tool.
Monitor traffic, SLAs, QoS, Medianet, WAAS etc. with NetFlow Analyzer
Customize your own dashboards, set traffic alerts and generate reports.
Network behavioral analysis & security monitoring. All-in-one tool.
http://pubads.g.doubleclick.net/gampad/clk?id=126839071&iu=/4140/ostg.clktrk