Delaying switch to master
Kjeld Flarup <[email protected]>
| Newsgroups | gmane.linux.keepalived.devel |
|---|---|
| Message-ID | <[email protected]> |
Hi everyone I have a VRRP setup, where I occasionally see that due to high load the master does not answer the slave. Thus the slave switches to master, and then back to slave immediately again because the master answers. I can't see a configuration options to let the slave be patient and wait a few seconds before it takes the master. I have a state-full service where a few seconds off-line is better than a server switch. -- Med venlig hilsen / Best regards Kjeld Flarup (Christensen) M.Sc E.E, Teknisk chef Viptel ApS, Benslehøjvej 3, DK-7470 Karup J Telefon: +45 46949949, Telefax: +45 46949950, http://viptel.dk ------------------------------------------------------------------------------ Site24x7 APM Insight: Get Deep Visibility into Application Performance APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month Monitor end-to-end web transactions and take corrective actions now Troubleshoot faster and improve end-user experience. Signup Now! http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 _______________________________________________ Keepalived-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/keepalived-devel