Re: SNMPd can register from one keepalived only
Vincent Bernat <[email protected]>
| Newsgroups | gmane.linux.keepalived.devel |
|---|---|
| Message-ID | <[email protected]> |
❦ 19 juillet 2016 11:30 CEST, Quentin Armitage <[email protected]> : > Thanks for the correction. When I configure "snmp_socket > udp:127.0.0.1:705" in keepalived.conf, and "agentxsocket > udp:127.0.0.1:705" in snmpd.conf the initialisation seems to work fine > and there is udp traffic to/from port 705. However, if I try using > snmpwalk to get the snmp data, there is no traffic from udp port 705, > and snmpwalk reports that it times out. Is there something that > keepalived is not setting that is needed for snmpd to talk back to > keepalived? Well, I don't think that anything else is needed. You can check the nsModuleTable to see what Net-SNMP thinks about that. -- Terminate input by end-of-file or marker, not by count. - The Elements of Programming Style (Kernighan & Plauger) ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports.http://sdm.link/zohodev2dev _______________________________________________ Keepalived-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/keepalived-devel