Re: Re: Can not get WUSB64G working!!

Hi,

in the latest dump you have provided, we can see that you are still 
using the same version of the Windows XP driver (09/09/2003, 0.6.0.0), 
did you tried with different versions of the Windows XP driver to see if 
there is a difference?

It seems that you are using a alpha/beta version of the Windows XP 
driver (version pre 1.0) and it could be the source of the problem.

Regards,


Jonathan
Technical specialist / Linuxant
www.linuxant.com
[email protected]



Joe LeBlanc wrote:
> Done both steps, still no go!
> 
> Here is some info:
> 
> $ dmesg
> usb 3-4.3: new high speed USB device using ehci_hcd and address 5
> driverloader: wusb20xp.sys: 0xe3081000..0xe30d3520 entry = e309cebf 
> (pbase = 0x10000)
> eth2: WPA, AES, TKIP, WEP128, WEP64 supported
> eth2: Linksys Wireless-G USB Network Adapter at 0000:00:02.24.3 (MAC 
> address 00:0F:66:16:BD:A8) ready
> eth2: New link status: Disconnected (0002)
> 
> $ iwconfig eth2
> eth2      IEEE 802.11g  ESSID:""  Nickname:"unknown"
>          Mode:Managed  Bit Rate=2 Mb/s           RTS thr:off   Fragment 
> thr:off
>          Encryption key:off
>          Power Management:off
>          Link Quality:0  Signal level:0  Noise level:0
>          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
>          Tx excessive retries:0  Invalid misc:0   Missed beacon:0
> $ iwconfig eth2 essid LWG12345
> 
> $ iwconfig eth2
> eth2      IEEE 802.11g  ESSID:"LWG12345"  Nickname:"unknown"
>          Mode:Managed  Bit Rate=2 Mb/s           RTS thr:off   Fragment 
> thr:off
>          Encryption key:off
>          Power Management:off
>          Link Quality:0  Signal level:0  Noise level:0
>          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
>          Tx excessive retries:0  Invalid misc:0   Missed beacon:0
> 
> $ ifconfig eth2
> eth2      Link encap:Ethernet  HWaddr 00:0F:66:16:BD:A8          
> BROADCAST MULTICAST  MTU:1500  Metric:1
>          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:1000
>          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
> 
> $ ifconfig eth2 up
> 
> $ ifconfig eth2
> eth2      Link encap:Ethernet  HWaddr 00:0F:66:16:BD:A8          UP 
> BROADCAST MULTICAST  MTU:1500  Metric:1
>          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:1000
>          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
> 
> $ iwconfig eth2
> eth2      IEEE 802.11g  ESSID:"LWG12345"  Nickname:"unknown"
>          Mode:Managed  Bit Rate=2 Mb/s           RTS thr:off   Fragment 
> thr:off
>          Encryption key:off
>          Power Management:off
>          Link Quality:0  Signal level:0  Noise level:0
>          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
>          Tx excessive retries:0  Invalid misc:0   Missed beacon:0
> 
> _______________________________________________
> driverloader mailing list
> [email protected]
> https://www.linuxant.com/mailman/listinfo/driverloader