Re: linksys wpc54g windows Driver not work on my Mandrake 10

Hi,

we can see the following errors in your 'dmesg':

---
PCI: No IRQ known for interrupt pin A of device 0000:06:00.0. Please try 
using pci=biosirq.
0000:06:00.0: cache line size not set; forcing 8
driverloader: NdisWriteErrorLogEntry: ErrorCode=DRIVER_FAILURE 
NumberOfErrorValues=1
driverloader: NdisWriteErrorLogEntry: ErrorValue 0=0x0000000a
eth1: failed to initialize adapter (err = -5)
eth1: Failed to register net device (-5)
---

It seems that your system have a important IRQ routing problem in the 
Linux kernel. Since you have the option 'apci=ht' on your kernel command 
line, please remove it to see if there is a difference. You can do this 
by manually changing the kernel command line or use the Mandrake Control 
Center to fully enable ACPI.

If it doesn't work, you could try to add the 'pci=biosirq' kernel boot 
parameter, as suggested by the kernel, to see if there is a difference.

Regards,


Jonathan
Technical specialist / Linuxant
www.linuxant.com
[email protected]



andimario wrote:
> Hi all,   
> 
> i have linksys card pcmcia wpc54g and windows driver installed by driver
> loader. but it seems that the driver didn't recognize my card.
> here the error message i got when i run
> http://127.0.0.1:18020/cgi-bin/config.cgi
> 
> It seems that your device is either not present or not supported by the
> installed driver(s). Either:
> 
> 1. Plug-in your device and click [Refresh] to retry, OR
> 2. Upload a new driver using the [Upload Windows Driver] button below.
> 
> If your device still does not appear, please look at the Kernel Messages
> for possible clues and check that no conflicting kernel modules are
> loaded.
> 
> can anyone help me on this?
> 
> here i attach the driverloaderdiag.txt
> 
> thanks
> 
> _______________________________________________
> driverloader mailing list
> [email protected]
> https://www.linuxant.com/mailman/listinfo/driverloader