Re: Could not run WLG 1500 in Ad-hoc Mode

Hi,

we do not see the MAC address of the other peer in the Ad Hoc network in 
the output of the 'iwconfig' command, this mean that you are not 
associated (connected). For Ad Hoc connections, unlike managed 
connections, you must setup the frequency (channel) used as well as the 
connection speed.

Regards,


Jonathan
Technical specialist / Linuxant
www.linuxant.com
[email protected]



Rohan Shrivastava wrote:
> Hi there,
> 
> I am unable to configure WLG 1500 USB adapter in Adhoc mode.
> I am using SuSE 9.0 Linux. At the other end there is PPC with Wi-Fi.
> 
> #iwconfig wlan0
> 
>   wlan0    IEEE 802.11-FH  ESSID:"adhoc"  Nickname:"linux"
>           Mode:Ad-Hoc  Frequency:2.462GHz  Bit Rate=11Mb/s  Tx-Power:18 dBm
>           RTS thr=2312 B  Fragment thr=2312 B
>           Encryption key:off
>           Power Management:off
>           Link Quality:0  Signal level:0  Noise level:0
>           Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
>           Tx excessive retries:0  Invalid misc:0  Missed beacon:0
> 
> 
> my essid is adhoc and the same essid is in my Pocket pc.
> But still I am unable to ping my PPC.
> 
> It shows the adhoc cell with in the list of scaned devices.
> (through "iwlist wlan0 scan" command).
> 
> As far as I know for connecting two system in Adhoc mode we need to keep 
> the essid same and the IP address should be in the same subnet, which is 
> correct in my case. Please tell me if I have to do more changes.
> 
> What could be the error in my process?
> 
> Any help will be highly appreciated.
> 
> Thanks
> -Rohan
> 
> 
> 
> 
> 
> 
> <http://adworks.rediff.com/cgi-bin/AdWorks/sigclick.cgi/www.rediff.com/signature-home.htm/1507191490@Middle5?PARTNER=3> 
> 
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> driverloader mailing list
> [email protected]
> https://www.linuxant.com/mailman/listinfo/driverloader