Re: CLI web browser & driverloader install

the dldrinstall.run script is nice...but I don't have an internet
connection on the pc that's wireless until I install the drivers.  I
have the .gz package, untar, make install, and sh dldrconfig.  How can
I set this up for a tty session?

Marty


On Fri, 19 Jan 2007 16:08:45 -0500
"Linuxant support (Jonathan)" <[email protected]> wrote:

> Hi,
> 
> lynx is not tested not supported and the layout will probably be quite 
> horrible since it was designed for graphical browsers.
> 
> You should start the installer with the following command:
> 
> ---
> sh dldrinstall.run -- --tty
> ---
> 
> This will launch the terminal (text) based version of the installer 
> which have all the features of the graphical, browser based ones.
> 
> Regards,
> 
> 
> Jonathan
> Technical specialist / Linuxant
> www.linuxant.com
> [email protected]
> 
> 
> 
> [email protected] wrote:
> > I now have my pc setup with Slackware 11 on an old pc that acts as a server.  I did not install a GUI session so I cannot install driverloader with Firefox at the end (it asks you for the Win drivers).  I can browse the webs with a CLI or text interface with Lynx.  How do I install driverloader with Lynx?
> > 
> > I found this on the Driverloader Advanced Install options page:
> > 
> > --browser <name> Use a specific web browser to do the installation. If the requested browser is not installed or cannot be started, the installer will abort. The list of supported browsers is: 
> > 
> > firefox
> > mozilla
> > netscape
> > konqueror
> > opera
> > 
> > Example: sh dldrinstall.run -- --browser konqueror
> >  
> > 
> > Can I use lynx as an option?
> > _______________________________________________
> > driverloader mailing list
> > [email protected]
> > https://www.linuxant.com/mailman/listinfo/driverloader