Re: Slackware 12 problem with WEP and driverloader

Hi,

you should read the documentation provided with Slackware to know how to 
configure a wireless interface, you will probably have to edit a 
configuration file to do it.

Alternatively, you can use the low-level command 'iwconfig <iface> key' 
to manually set the WEP key. This method is only recommended for 
advanced users that know what they are doing.

Regards,


Jonathan
Technical specialist / Linuxant
www.linuxant.com
[email protected]



Marty Huntzberry wrote:
> they aren't that old!
> 
> On Mon, 03 Sep 2007 18:42:19 -0400
> Marty Huntzberry <[email protected]> wrote:
> 
> I've been using driverloader for over a year with almost no problems in Slackware till now.  Slackware updated to Slackware 12 a couple months ago.
> Since then I can only use driverloader 2.38 to connect to my wireless router when WEP is not used (WPA is not available on this).
> 
> lspci shows this about my wireless Belkin G PCI card:
> 
> Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller (rev 02)
> 
> I am running kernel 2.6.22.1 that I built myself and works fine with driverloader 2.38 in Slackware 11 in an old pentium tower that I use as a
> tower. My pc doesn't run an X session.  Anyone know how I can get my 128 bit WEP working?  
> 
> Marty
> _______________________________________________
> driverloader mailing list
> [email protected]
> https://www.linuxant.com/mailman/listinfo/driverloader
> 
> 
> 
>      ><>Marty<><
> 
> Visit my web site: http://777.servemp3.com
> _______________________________________________
> driverloader mailing list
> [email protected]
> https://www.linuxant.com/mailman/listinfo/driverloader