Re: driveloader and WEP - unable to connect with ENCRYPTION (e.g. WEP) on

gab jones <[email protected]> Wed, 4 Jun 2008 01:52:18 +0000
Newsgroups gmane.linux.kernel.driver-loader
Message-ID <[email protected]>
--===============1528100985==
Content-Type: multipart/alternative;
	boundary="_16d7cdd6-43d7-4614-8683-53f76acc206d_"

--_16d7cdd6-43d7-4614-8683-53f76acc206d_
Content-Type: text/plain; charset="Windows-1252"
Content-Transfer-Encoding: quoted-printable


Hi,
=20
Thanks for the reply
=20
1) How do you input the WEP key under Linux?
=20
I currently enter the WEP in linux using the neat command (System tools > n=
etwork device) which brings up the interface device listings via the gui. i=
then click on interface eth1 in the gui and put the details of the WEP key =
in there 9i forget what tab it is now)
=20
I can connect to the wireless with my windows XP laptops
Regards,
=20
gab> Date: Tue, 3 Jun 2008 18:00:00 -0400> From: [email protected]> To: =
[email protected]> CC: [email protected]> Subject: Re: [d=
riverloader] driveloader and WEP - unable to connect with ENCRYPTION (e.g. =
WEP) on> > Hi,> > in the dump you sent to [email protected], I do not se=
e any obvious > problems. The installer Windows driver does support WPA, WP=
A2, AES, > TKIP, WEP128 and WEP64, so 64 and 128 bits WEP keys should be su=
pported.> > With WEP keys there are things to be aware of. First of all, th=
ey come > in 2 formats, hex and ASCII ones so make sure that both the acces=
s point > and the configuration tool use the same format. You could also tr=
y with > different security mode settings, i.e. open, restricted, etc...> >=
 You should also try to connect to the access point using another device > =
or operating system just to make sure that the access point is correctly > =
configured. How do you input the WEP key under Linux?> > Regards,> > > Jona=
than> Technical specialist / Linuxant> www.linuxant.com> [email protected]=
om> > > > gab jones wrote:> > Hi,> > > > I currently downloaded the trial f=
or driverloader download.> > > > May I say what a fresh of breath air this =
tool is having been trying to configure wireless for my RHEL 4 linux laptop=
 with ipw2200 card for 5 days to no avail.> > > > The driveloader install w=
as very easy.> > > > Now to my onlyhiccup/issue.> > > > 1) I can connect to=
 my linksys WRT54GS wireless router with ENCRYPTION (e.g. WEP) off and bang=
 my wireless works> > > > 2) But when I enable the WEP encryption I can not=
 connect at all and I always get the below in tail -f /var/log/messages> > =
> > Jun 3 20:57:30 localhost kernel: ADDRCONF(NETDEV_UP): eth1: link is not=
 ready> > Jun 3 20:57:35 localhost dhclient: DHCPREQUEST on eth1 to 255.255=
.255.255 port 67> > Jun 3 20:57:39 localhost dhclient: DHCPREQUEST on eth1 =
to 255.255.255.255 port 67> > Jun 3 20:57:48 localhost dhclient: DHCPDISCOV=
ER on eth1 to 255.255.255.255 port 67 interval 8> > Jun 3 20:57:56 localhos=
t dhclient: DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval 18> > =
Jun 3 20:58:14 localhost dhclient: DHCPDISCOVER on eth1 to 255.255.255.255 =
port 67 interval 14> > Jun 3 20:58:28 localhost dhclient: DHCPDISCOVER on e=
th1 to 255.255.255.255 port 67 interval 20> > Jun 3 20:58:48 localhost dhcl=
ient: DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval 1> > Jun 3 2=
0:58:49 localhost dhclient: No DHCPOFFERS received.> > > > Please and advic=
e will be greatly appreciated?> > > > Regards,> > > > Gab> > ______________=
___________________________________________________> > Instantly invite fri=
ends from Facebook and other social networks to join you on Windows Live=99=
 Messenger.> > https://www.invite2messenger.net/im/?source=3DTXT_EML_WLH_In=
viteFriends> > _______________________________________________> > driverloa=
der mailing list> > [email protected]> > https://www.linuxant=
.com/mailman/listinfo/driverloader
_________________________________________________________________
Now you can invite friends from Facebook and other groups to join you on Wi=
ndows Live=99 Messenger. Add now.
https://www.invite2messenger.net/im/?source=3DTXT_EML_WLH_AddNow_Now=

--_16d7cdd6-43d7-4614-8683-53f76acc206d_
Content-Type: text/html; charset="Windows-1252"
Content-Transfer-Encoding: quoted-printable

<html>
<head>
<style>
.hmmessage P
{
margin:0px;
padding:0px
}
body.hmmessage
{
FONT-SIZE: 10pt;
FONT-FAMILY:Tahoma
}
</style>
</head>
<body class=3D'hmmessage'>
Hi,<BR>
&nbsp;<BR>
Thanks for the reply<BR>
&nbsp;<BR>
1) <EM>How do you input the WEP key under Linux?</EM><BR>
<EM></EM>&nbsp;<BR>
I currently enter the WEP in linux using the neat command (System tools &gt=
; network device) which brings up the interface device listings via the gui=
. ithen click on interface eth1 in the gui and put the details of the WEP k=
ey in there 9i forget what tab it is now)<BR>
&nbsp;<BR>
I can connect to the wireless with my windows XP laptops<BR>
<BR>Regards,<BR>
&nbsp;<BR>
gab<BR>&gt; Date: Tue, 3 Jun 2008 18:00:00 -0400<BR>&gt; From: support@linu=
xant.com<BR>&gt; To: [email protected]<BR>&gt; CC: [email protected]=
inuxant.com<BR>&gt; Subject: Re: [driverloader] driveloader and WEP - unabl=
e to connect with ENCRYPTION (e.g. WEP) on<BR>&gt; <BR>&gt; Hi,<BR>&gt; <BR=
>&gt; in the dump you sent to [email protected], I do not see any obviou=
s <BR>&gt; problems. The installer Windows driver does support WPA, WPA2, A=
ES, <BR>&gt; TKIP, WEP128 and WEP64, so 64 and 128 bits WEP keys should be =
supported.<BR>&gt; <BR>&gt; With WEP keys there are things to be aware of. =
First of all, they come <BR>&gt; in 2 formats, hex and ASCII ones so make s=
ure that both the access point <BR>&gt; and the configuration tool use the =
same format. You could also try with <BR>&gt; different security mode setti=
ngs, i.e. open, restricted, etc...<BR>&gt; <BR>&gt; You should also try to =
connect to the access point using another device <BR>&gt; or operating syst=
em just to make sure that the access point is correctly <BR>&gt; configured=
. How do you input the WEP key under Linux?<BR>&gt; <BR>&gt; Regards,<BR>&g=
t; <BR>&gt; <BR>&gt; Jonathan<BR>&gt; Technical specialist / Linuxant<BR>&g=
t; www.linuxant.com<BR>&gt; [email protected]<BR>&gt; <BR>&gt; <BR>&gt; =
<BR>&gt; gab jones wrote:<BR>&gt; &gt; Hi,<BR>&gt; &gt; <BR>&gt; &gt; I cur=
rently downloaded the trial for driverloader download.<BR>&gt; &gt; <BR>&gt=
; &gt; May I say what a fresh of breath air this tool is having been trying=
 to configure wireless for my RHEL 4 linux laptop with ipw2200 card for 5 d=
ays to no avail.<BR>&gt; &gt; <BR>&gt; &gt; The driveloader install was ver=
y easy.<BR>&gt; &gt; <BR>&gt; &gt; Now to my onlyhiccup/issue.<BR>&gt; &gt;=
 <BR>&gt; &gt; 1) I can connect to my linksys WRT54GS wireless router with =
ENCRYPTION (e.g. WEP) off and bang my wireless works<BR>&gt; &gt; <BR>&gt; =
&gt; 2) But when I enable the WEP encryption I can not connect at all and I=
 always get the below in tail -f /var/log/messages<BR>&gt; &gt; <BR>&gt; &g=
t; Jun 3 20:57:30 localhost kernel: ADDRCONF(NETDEV_UP): eth1: link is not =
ready<BR>&gt; &gt; Jun 3 20:57:35 localhost dhclient: DHCPREQUEST on eth1 t=
o 255.255.255.255 port 67<BR>&gt; &gt; Jun 3 20:57:39 localhost dhclient: D=
HCPREQUEST on eth1 to 255.255.255.255 port 67<BR>&gt; &gt; Jun 3 20:57:48 l=
ocalhost dhclient: DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval=
 8<BR>&gt; &gt; Jun 3 20:57:56 localhost dhclient: DHCPDISCOVER on eth1 to =
255.255.255.255 port 67 interval 18<BR>&gt; &gt; Jun 3 20:58:14 localhost d=
hclient: DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval 14<BR>&gt=
; &gt; Jun 3 20:58:28 localhost dhclient: DHCPDISCOVER on eth1 to 255.255.2=
55.255 port 67 interval 20<BR>&gt; &gt; Jun 3 20:58:48 localhost dhclient: =
DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval 1<BR>&gt; &gt; Jun=
 3 20:58:49 localhost dhclient: No DHCPOFFERS received.<BR>&gt; &gt; <BR>&g=
t; &gt; Please and advice will be greatly appreciated?<BR>&gt; &gt; <BR>&gt=
; &gt; Regards,<BR>&gt; &gt; <BR>&gt; &gt; Gab<BR>&gt; &gt; _______________=
__________________________________________________<BR>&gt; &gt; Instantly i=
nvite friends from Facebook and other social networks to join you on Window=
s Live=99 Messenger.<BR>&gt; &gt; https://www.invite2messenger.net/im/?sour=
ce=3DTXT_EML_WLH_InviteFriends<BR>&gt; &gt; _______________________________=
________________<BR>&gt; &gt; driverloader mailing list<BR>&gt; &gt; driver=
[email protected]<BR>&gt; &gt; https://www.linuxant.com/mailman/lis=
tinfo/driverloader<BR><BR><br /><hr />Now you can invite friends from Faceb=
ook and other groups to join you on Windows Live=99 Messenger. <a href=3D'h=
ttps://www.invite2messenger.net/im/?source=3DTXT_EML_WLH_AddNow_Now' target=
=3D'_new'>Add them now!</a></body>
</html>=

--_16d7cdd6-43d7-4614-8683-53f76acc206d_--

--===============1528100985==
Content-Type: text/plain; charset="us-ascii"
MIME-Version: 1.0
Content-Transfer-Encoding: 7bit
Content-Disposition: inline

_______________________________________________
driverloader mailing list
[email protected]
https://www.linuxant.com/mailman/listinfo/driverloader
--===============1528100985==--