Re: wireless device is not detecting...........

Hi,

you have correctly identified the source of the problem. We do offer 
pre-compiled 16K stacks kernel packages for RHEL5 and CentOS, they can 
be downloaded at:

http://www.linuxant.com/driverloader/wlan/full/downloads-rhel5-kernel-x86.php

You should install one of these kernels, boot it and try again to use 
DriverLoader again.

Regards,


Jonathan
Technical specialist / Linuxant
www.linuxant.com
[email protected]



SHARANGA JAYATILAKE wrote:
> 
>     Hi,
> 
>     When I upload my device drivers, the driver loader web page displays
>     no devices found. I have attached the dumpdiag report and kernel
>     messages.
>     I think usr11g files need kernel stack size of 8K to run but my
>     kernel is 4K. If this
>     the exact problem please advise me how to change the stack size to 8K.
> 
>     Thank you.
>     ----------------------------------------------------------------------------------------------
> 
>     dldrengine: module license 'see LICENSE file; Copyright (c)2003-2004 Linuxant inc.' taints kernel.
>     dldrengine: stack=4096/64/0 REGPARM SMP
>     driverloader: driver "usr11g" requires minimum kernel stack of 8K, only 4K available
>     driverloader: Rebuild your kernel with larger stack size.
>     driverloader: Replacement Fedora Core 2 kernel pkgs are also available from www.linuxant.com
>     driverloader: probe of 0000:03:00.0 failed with
>      error -12
>     usbcore: registered new driver driverloader
>     Bluetooth: HIDP (Human Interface Emulation)   ver 1.1
>     eth0: no IPv6 routers present
>     [drm] Initialized drm 1.0.1 20051102
>     ACPI: PCI Interrupt 0000:00:02.0[A] -> GSI 16 (level, low) -> IRQ 193
>     [drm] Initialized i915 1.8.0 20060929 on minor 0
> 
> 
> _______________________________________________
> driverloader mailing list
> [email protected]
> https://www.linuxant.com/mailman/listinfo/driverloader