[PATCH v1] firewire: Correct some typos

Fixed some confusing typos that were currently identified with codespell,
the details are as follows:

drivers/firewire/core-topology.c:59: containted ==> contained
drivers/firewire/core.h:83: reenable ==> re-enable
drivers/firewire/ohci.c:1387: apppends ==> appends
drivers/firewire/ohci.c:2216: superceded ==> superseded
drivers/firewire/ohci.c:2617: litte ==> little

Signed-off-by: Shen Lichuan <[email protected]>
---
 drivers/firewire/core-topology.c | 2 +-
 drivers/firewire/core.h          | 2 +-
 drivers/firewire/ohci.c          | 6 +++---
 3 files changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/firewire/core-topology.c b/drivers/firewire/core-topology.c
index 6adadb11962e..baba31933667 100644
--- a/drivers/firewire/core-topology.c
+++ b/drivers/firewire/core-topology.c
@@ -56,7 +56,7 @@ static struct fw_node *fw_node_create(u32 sid, int port_count, int color)
  * two cases: either the path goes through this node, in which case
  * the hop count is the sum of the two biggest child depths plus 2.
  * Or it could be the case that the max hop path is entirely
- * containted in a child tree, in which case the max hop count is just
+ * contained in a child tree, in which case the max hop count is just
  * the max hop count of this child.
  */
 static void update_hop_count(struct fw_node *node)
diff --git a/drivers/firewire/core.h b/drivers/firewire/core.h
index 0ae2c84ecafe..9b298af1cac0 100644
--- a/drivers/firewire/core.h
+++ b/drivers/firewire/core.h
@@ -80,7 +80,7 @@ struct fw_card_driver {
 	/*
 	 * Allow the specified node ID to do direct DMA out and in of
 	 * host memory.  The card will disable this for all node when
-	 * a bus reset happens, so driver need to reenable this after
+	 * a bus reset happens, so driver need to re-enable this after
 	 * bus reset.  Returns 0 on success, -ENODEV if the card
 	 * doesn't support this, -ESTALE if the generation doesn't
 	 * match.
diff --git a/drivers/firewire/ohci.c b/drivers/firewire/ohci.c
index 7ee55c2804de..4dbd20360223 100644
--- a/drivers/firewire/ohci.c
+++ b/drivers/firewire/ohci.c
@@ -1384,7 +1384,7 @@ struct driver_data {
 };
 
 /*
- * This function apppends a packet to the DMA queue for transmission.
+ * This function appends a packet to the DMA queue for transmission.
  * Must always be called with the ochi->lock held to ensure proper
  * generation handling and locking around packet queue manipulation.
  */
@@ -2213,7 +2213,7 @@ static irqreturn_t irq_handler(int irq, void *data)
 
 	if (unlikely(param_debug > 0)) {
 		dev_notice_ratelimited(ohci->card.device,
-				       "The debug parameter is superceded by tracepoints events, and deprecated.");
+				       "The debug parameter is superseded by tracepoints events, and deprecated.");
 	}
 
 	/*
@@ -2614,7 +2614,7 @@ static int ohci_set_config_rom(struct fw_card *card,
 	 * ConfigRomHeader and BusOptions doesn't honor the
 	 * noByteSwapData bit, so with a be32 config rom, the
 	 * controller will load be32 values in to these registers
-	 * during the atomic update, even on litte endian
+	 * during the atomic update, even on little endian
 	 * architectures.  The workaround we use is to put a 0 in the
 	 * header quadlet; 0 is endian agnostic and means that the
 	 * config rom isn't ready yet.  In the bus reset tasklet we
-- 
2.17.1