Re: [PATCH v1] firewire: ohci: use generic power management

On Sat, Dec 7, 2024 at 2:13 AM Takashi Sakamoto <[email protected]> wrote:
>
> Hi,
>
> On Mon, Jul 20, 2020 at 08:37:16PM +0530, Vaibhav Gupta wrote:
> > Drivers using legacy PM have to manage PCI states and device's PM states
> > themselves. They also need to take care of configuration registers.
> >
> > With improved and powerful support of generic PM, PCI Core takes care of
> > above mentioned, device-independent, jobs.
> >
> > This driver makes use of PCI helper functions like
> > pci_save/restore_state(), pci_disable_device() and pci_set_power_state() to
> > do required operations. In generic mode, they are no longer needed.
> >
> > Change function parameter in both .suspend() and .resume() to
> > "struct device*" type. Use to_pci_dev() to get "struct pci_dev*" variable.
> >
> > Compile-tested only.
> >
> > Signed-off-by: Vaibhav Gupta <[email protected]>
> > ---
> >  drivers/firewire/ohci.c | 43 ++++++++++++-----------------------------
> >  1 file changed, 12 insertions(+), 31 deletions(-)
>
> Although it takes a long time since the patch was posted, I applied it
> now to for-next branch with my handy changes to optimize to v6.13-rc1.
>
> I still have a slight concern about the operation specific to powermac
> platforms, however let us fix when receiving any reports from the users.
>
>
> Regards
>
> Takashi Sakamoto

Hey Takashi,

Thank you so much! One more step closer to getting rid of legacy stuff.

Yes, I will also keep a look on the mailing list for if someone
reports an issue.

Best
Vaibhav Gupta