Enable UART after driver removal without reboot
Ayush Singh <[email protected]>
| Newsgroups | gmane.linux.kernel.kernelnewbies |
|---|---|
| Message-ID | <[email protected]> |
Hello everyone. I have a Linux Serdev driver [1] that uses a specific UART. To actually access the UART directly (`/dev/ttyS4`), I have to enable a device tree [2] and reboot the device. I was wondering if there was a better way to go about it. Is it possible to disable bcfserial (thereby enabling `/dev/ttyS4`) when the driver is removed (using rmmod)? I need access to `/dev/ttyS4` to flash new firmware to BeaglePlay CC1352 using bsl [3]. Having to restart everytime I or anyone else wants to update firmware is not great, while developing. I am looking for a cycle like this: `rmmod driver` -> `flash firmware` -> `modprobe driver`. Ayush Singh [1]: https://git.beagleboard.org/gsoc/greybus/beagleplay-greybus-driver/-/tree/develop [2]: https://git.beagleboard.org/beagleboard/linux/-/blob/v5.10.168-ti-arm64-r108/arch/arm64/boot/dts/ti/overlays/k3-am625-beagleplay-bcfserial-no-firmware.dts [3]: https://git.beagleboard.org/beagleconnect/zephyr/zephyr/-/blob/sdk-next/boards/arm/beagle_play_cc1352/cc2538-bsl.py _______________________________________________ Kernelnewbies mailing list [email protected] https://lists.kernelnewbies.org/mailman/listinfo/kernelnewbies