Re: How to filter the control flow with CPU_ID
Mathieu Desnoyers <[email protected]>
| Newsgroups | gmane.linux.kernel.tracing |
|---|---|
| Message-ID | <20070712162245.GA30696@Krystal> |
* CASTOR, Mikael ([email protected]) wrote: > Hello, > > I'm working on a multi-cpu computer, and I tried to apply filters to only have process from required processor, but I don't find how to do so. > I would like to know how it is possible to filter the control flow by the CPU of the process. In order to have only the tasks of the requested CPU. > Hi, An expression like this should do what you want: state.cpu=N Does it help ? > > Sincerly, > > Mikaël Castor. > > This e-mail is intended only for the above addressee. It may contain privileged information. > If you are not the addressee you must not copy, distribute, disclose or use any of the information in it. > If you have received it in error please delete it and immediately notify the sender. > Security Notice: all e-mail, sent to or from this address, may be accessed by someone other than the recipient, for system management and security reasons. This access is controlled under Regulation of security reasons. > This access is controlled under Regulation of Investigatory Powers Act 2000, Lawful Business Practises. > > > _______________________________________________ > Ltt-dev mailing list > [email protected] > http://listserv.shafik.org/mailman/listinfo/ltt-dev -- Mathieu Desnoyers Computer Engineering Ph.D. Student, Ecole Polytechnique de Montreal OpenPGP key fingerprint: 8CD5 52C3 8E3C 4140 715F BA06 3F25 A8FE 3BAE 9A68